Lian Li PC-A77FR Guía de instalación

Busca en linea o descarga Guía de instalación para Cajas De Ordenadores Lian Li PC-A77FR. Lian Li PC-A77FR computer case Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Case component
Power switch button
Reset switch button
Multi-media port
5.25”
mounting
bracket
with air filter
Power LED
HDD LED
VGA card
pillar
Removable HDD module
with 140mm fan
C50.A77F0.00E-1
Remove six
thumb screws.
Slide panel backward of the case.
Installation Guide
120mm fan
Patented tool-less 5.25”
device mounting
Patented tool-less PSU
mounting bracket
Rubberized grommets
for liquid cooling
system’s tubing
Patented tool-less
PCI add-on card holder
Press the right and left side of the
bezel to remove.
Remove the mounting bezel
Hardware list
Mounting bracket
for SSI CEB/EEB M/B
(5)
(3)
(18)
Box(1)
for spare parts
Longer vision thumb screw(3)
for mother board mount
for work with stand-off
Thumb screw(24)
for HDD
Thumb screw(1)
Rubber ring(24)
for HDD
Shorter vision thumb screw(9)
for mother board mount
for PSU mounting
Bracket(1)
for power supply mounting
Hex wrench for M/B(1)
stand-off
for cable management
1
Secure the stand-off bolts on the M/B tray which match
with the M/B fix points,place the M/B on the copper bolt,
fasten with the thumb screws to secure.
for SSI CEB/EEB
The oval hole on M/B tray
designed for special server
boards, please use nut to
hold the copper bolt in place.
Note: For area where hard to
reach use the long
thumb screw
!
!
!
POWER SW
RESET SW
POWER
LED
H.D.D LED
SPEAKER
WHITE
GRAY
WHITE
BLUE
WHITE
NC
GREEN
WHITE
ORANGE
BLACK
NC
NC
RED
GROUND
PWR
GROUND
Reset
PLED-
PLED+
IDE_LED-
IDE_LED+
Speaker
+5V
Front panel cable installation guide
Slide the HDD into the front HDD cage
Hard disk installation for the front HDD cage
Close the gate to secure the HDD.
Install the screws to the HDD with
anti-vibration rubber rings.
Push the ODD into the 5.25” rack,
close the bracket to secure the
ODD
ODD installation
1. Pull the front panel to remove it.
2. Release the 5.25" bezel
3. Press plastic handle to release the mounting bracket.
PCI card holder-S(2)
PCI card holder-L(5)
Thumb screw(7)
for PCI card holder
USB3.0 to USB2.0
convertor (1)
140mm fan
PCI bracket (1)
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Installation Guide

Case componentPower switch buttonReset switch buttonMulti-media port5.25” mounting bracketwith air filterPower LEDHDD LEDVGA card pillarRemovable HDD

Pagina 2 - USB3.0 to USB2.0 convertor

E-SATAConnectorI/O port installationPSU installation Place the PSU on the stand, and push again the rear panel.Place the PSU bracket into according sl

Comentarios a estos manuales

Sin comentarios